Parts Included With Kit:

1. One shelf or valance


2. One mounting strip *Two with corner shelf


3. One hardware kit

Hardware Kit Included:

1. 2- 2 1/2" screws per mounting strip

Tools And Supplies Needed:

1. Level


2. Electric drill with # 2 phillips bit


3. Pencil


4. Construction adhesive

Step 1
Using a level, position the product on the wall at your desired location.

Step 2
Draw a pencil line along the top edge of the product.

Step 3
Remove the product. Locate the studs in the wall. Place the mounting board 1/4" below the pencil line. Use pre-drilled counter-sink holes (the holes are 16" apart on the center when applicable) to screw mounting board to the studs in the wall.
NOTE:Product must be attatched to two studs in the wall. For our smaller products at least one stud is required. Failure to do this could result in serious injury. For a more secure support, construction adhesive can be placed on the back edge of mounting board attaching it to the wall.

Step 4
Place product on wall so the mounting strip bevel matches up with the opposite product bevel (see illustration below).